Design

1. CAD Modeling of LP Turbine Blade and Vane

2. Non-contact Scanning & Reverse Engineering of Aero Engine Compressor Blades

3. Design, 3D Modeling, Fabrication and Commissioning of Cascade Wind Tunnel

4. Design and Development of 2Stage 3D Boundary Layer Traverse Gear

5. Design, Development, Fabrication and Installation of 2Stage 3D Boundary Layer Traverse Gear - Secondary Traverse Unit

6. Design, Development, Fabrication and Installation of 2Stage 3D Boundary Layer Traverse Gear - Primary Traverse Unit

7. Failure Detection of Hydraulic Actuators

8. Design for A350 Main Landing Gear and Nose Landing Gear door Actuators

9. 3D models and manufacturing drawing of Landing Gear Actuators, Valves and Landing Gear assembly test fixtures

10. 3D models and manufacturing drawing of landing engine components

Analysis
 

1. Bird Impact analysis on the bullet nose of an Aero-Engine using LS-Dyna with an objective to determine the structural stability

2. Aero Engine CD Nozzle Kinematic Analysis for Design Optimization using ADAMS. Kinematic analysis with aerodynamic forces with validation, Lever length sensitivity analysis and Link failure-effect analysis.

3. Conjugate Heat Transfer Analysis of Secondary Flow in a Gas Turbine using FLUENT Estimation of Compressor and Turbine Disc Temperatures & Secondary air temperature rise

4. CFD investigation of can-type combustor and assessment of diffusion flame combustion models using FLUENT to investigate fluid flow and combustion phenomena

5. CFD Analysis of 2D and axisymmetric nozzle using Fluent to study behavior of flow through CD nozzles for two-dimensional and axis-symmetric cases

6. Aerodynamic analysis of a Radar rome mounted on an Aircraft using FLUENT to compute the drag and lift forces and to determine the reaction forces on the support struts.